Seagate blackarmor nas 110 software download for mac
- #SEAGATE BLACKARMOR NAS 110 SOFTWARE DOWNLOAD FOR MAC HOW TO#
- #SEAGATE BLACKARMOR NAS 110 SOFTWARE DOWNLOAD FOR MAC INSTALL#
Update: It works on the BA440 (reported by Isaac_X) Update: It works on the BA110 (reported by tuxmania) Update: It works on the BA420 (reported by lnxmnky) This modification has been tested on a BA220 with fw 2000.0631. Has done this laborious work (forward port Seagates h/w-specific patches, You would have to update the kernel image first. ) require an updated kernel udev subsystem and therefore Partition 4) is compatible with Debian Lenny. You'll get weird errors about missing dependencies.Īnd add this line to (nano /etc/apt/sources.list) your list of sources. Run 'apt-get update' before installing any new packages. Make sure to change the root password as soon as possible. For configuration, you'll have to use your favourite text
#SEAGATE BLACKARMOR NAS 110 SOFTWARE DOWNLOAD FOR MAC INSTALL#
However, you areįree to install additional packages via the Debian package management System (basic system binaries and SSH daemon only). After applying the SP, the system starts with a Debian Lenny minimal This SP does not replace the linux kernel image and thereforeĭoes not depend on any specific hardware.
#SEAGATE BLACKARMOR NAS 110 SOFTWARE DOWNLOAD FOR MAC HOW TO#
Harddisk if you want to restore to factory defaults (check here how to completely erase a hdd so as to restore)). The GPT partition table which is located at the *end* of the Official firmware gets installed (make sure to completely remove If you insert clean harddisks into your NAS, the The SP does not overwrite the official firmware image (NAND flash Should not affect the normal operation of the NAS (e.g. Is the correct way to start the init process). Partition 2) to fix some bugs (Seagate/Wistron guys: 'exec /sbin/init' The SP modifies the original Seagate preroot image (NAND flash (rename the file to '' before uploading)Īfter Debian installation, try to scan your network for new IPs!) The manual firmware upgrade process through the web interface: Download Hojo's unofficial 'fw upgrade' service pack (SP99) and use Upload both files to the 'Public' share of your NAS. Download my customized Debian GNU/Linux image (2 files): Installation of the Debian/GNU Linux system is only recommendedįor people with (at least) basic linux administration skills. Possibly damage your device permanently! You have been warned! WARNING: This process completely replaces the original Seagateįirmware! The SP modifies the NAND flash of your NAS. Install Debian GNU/Linux 5.0.7 (Lenny) on the Blackarmor 110 NAS Just issue the passwd command for that to happen.Ģ. Make sure to change the root password as soon as possible!
Or open PuTTY and put the IP, then accept the key, then username:root and password:atsahs